WHAT YOU NEED

PURCHASE CONNECT VIEW

The ContourGPS camera requires the Contour Connect View card to connect with a supported Apple iOS device. Available at retailers, the card slides into the slot located next to the battery.

Locate a dealer

INSTALL NEW FIRMWARE

To unlock the Bluetooth® feature in your camera, you will need to install new firmware into your ContourGPS camera and connect to Storyteller to get a Bluetooth id.

Complete Directions

DOWNLOAD CONTOUR APP

Visit the App Store to find the Contour Camera app. Made for iPhone 4, iPhone 3G, iPhone 3GS, and iPod touch (3rd and 4th generation).

App Store


DIRECTIONS

HERE'S HOW TO PAIR YOUR CAMERA WITH YOUR iOS DEVICE:

1

Before starting, make sure you have updated the camera's firmware and connected to Storyteller to get a Bluetooth id. (Directions)
Open the backdoor of the camera and remove the battery. Replace the card next to the battery with the Connect View card. Close the backdoor and power up the camera.

2

Locate the Bluetooth button in front of the record switch. Press and hold the button for five seconds before releasing. The front LED will begin flashing blue. (Note: if you slide the record switch forward the camera will go out of Bluetooth mode.)

3

Go into your phone's settings and enable Bluetooth. Wait while your iOS locates the ContourGPS camera. Once you see 'ContourGPS', select it to tell your iOS to accept the pairing. You will know the pairing is complete when the front LED on the camera goes solid blue.
If a pairing can not be established, push and release the Bluetooth button on the camera. Then repeat the process of pressing and holding the camera's Bluetooth button for five seconds. The ContourGPS camera should appear.

4

Open the Contour App and you should see what your camera sees! If your Bluetooth connection is lost the app will let you know; if this happens, you'll need to turn your Bluetooth back on by pressing the Bluetooth button once. A single beep will sound and the camera will connect with the pre-existing pairing.

(Full Release Notes)